Pillow packaging machine is a new type of automatic continuous shrink packaging equipment in China. Using ordinary electric wire heating method. It has the characteristics of fast heating, good stability, low maintenance cost, etc. The shrinkage temperature and motor transmission speed are stable and adjustable. Wide adjustment range; drum rotating device can work continuously.
1.When the product seal of the pillow packaging machine is wrinkled, this is caused by the high temperature and slow speed of the pillow packaging machine during operation; the solution is to adjust the temperature to a suitable range, which is to improve the performance of the pillow packaging machine. Rotating speed.
2.When the cutting knife of the pillow packaging machine cuts the product, it means that the height of the knife seat of the pillow packaging machine is not suitable, the packaging speed is too fast, and the push rod and the cutting knife will not be executed at the same time. The solution at this time is to adjust the packaging speed of the pillow packaging machine and adjust the height of the knife holder.
3.The products produced by the pillow packaging machine deviate from the color code, which proves that the film color code is too light and the film drive slips. The solution at this time is to adjust its sensitivity; the tracking mode of the pillow packaging machine is switched to "tracking cutting".
4.when the temperature gauge of the pillow packaging machine cannot control the temperature, it is the damage of the solid-state circuit breaker, or the temperature control gauge may be broken. The solution at this point is to replace the thermostat and replace the solid state circuit breaker.
5.When the sealing of the pillow packaging machine is not firm, it may be that the speed of the pillow packaging machine is too fast. Needless to say, the solution at this point is to appropriately reduce the types of pillows. The speed of the packaging machine.
6.When the temperature is too high, the speed is too slow, and the heat resistance of the outer layer of the coating is poor, there will be traces of scorch wrinkles on the seal. The maintenance method is to adjust the speed, lower the temperature, and replace the film material.
7.The knife seat is too high or too low, the packaging speed is too fast, and when the push rod and the cutter are not synchronized, the cutter will cut on the product. The maintenance method is to reduce the packaging speed and adjust the height of the end sealing parts so that the center of the sealing knife is in the middle of the product height.
8.The color of the film color mark is too light, the film drive is slippery, and the cutting position will deviate from the color mark when the color mark tracking is not turned on. The maintenance method is to refer to the manual of the packaging machine and adjust its sensitivity; in the man-machine dialogue interface, switch the tracking mode to "tracking cut".
9.The solid-state circuit breaker is burned out, the temperature control meter is damaged, and the thermometer cannot control the temperature when the thermocouple is damaged. The maintenance method is to replace the electric couple, replace the temperature control meter (see the picture on the right), and replace the heating element.
10. If the speed is too fast, the inner layer of the coating has poor heat sealing performance. When the temperature is too low, the sealing will be leaked or not firm. The method of maintenance is to slow down the speed, increase the temperature, and replace the material of the film.
11.The air pressure is wrong, the cylinder swing rod is loose, the heating temperature is low, and the heat sealing roller is not parallel to the transmission roller, which will cause poor heat sealing. The maintenance method is to adjust the parallelism, adjust the temperature and air pressure to tighten it.
After receiving your inquiry, We will send you the quotation as soon as possible
